we were given 2 peices of d4s timber at 300mm long. d4s= dressed 4 sides. and told to turn them into the oil stone case that was on the instruction sheet. once i had marked the stone size onto the wood i chiseled around the edge about 3mm inside the my mark to keep the edge from chipping off. to do this i used a rule and pencil to mark out the messurements and to guide me where to chisel and how deep to go. after chiseling the center out for the stone to sit in i did the same with the top peace of timber exactly the same. the bottom of case had to be pressure tight to keep the stone in and the top of the case was 1mm looser so the stone was easy to access. after case was made i put the top peace back in the vice to plane the top to make it prezentable and so it matched the task sheet. the messurments were 35mm in center form each end and then planed 5mm 45degree pitch ether side of center.
HAND TOOLS WE USED :
-hammer
-chizle
-pencil
-rule
-plane
-vic
No comments:
Post a Comment